Wasp-barcode WLS9600 Product Reference Guide Uživatelský manuál stáhnout pdf (Strana 264)

References

254

WLS9600

Scanning Features

Scan Mode

This mode is associated with typical handheld reader operation. Selects the scan operating mode

for the reader. The following selections are valid for all models:

Trigger Single.

When the trigger is pulled, scanning is activated until one of the following

occurs:

- Scanning Active Time has elapsed

- a label has been read

- the trigger is released

Trigger Hold Multiple.

When the trigger is pulled, scanning starts and the product scans until

the trigger is released or Scanning Active Time has elapsed. Reading a label does not disable

scanning. Double Read Timeout prevents undesired multiple reads of the same label while in

this mode.

Trigger Pulse Multiple.

When the trigger is pulled, continuous scanning is activated until

Scanning Active Time has elapsed or the trigger has been released and pulled again. Do

uble

Read Timeout prevents undesired multiple reads of the same label while in this mode.

Flashing.

The reader flashes

on and off regardless of the trigger status. Flash rate is controlled

by Flash On Time and Flash Off Time. When Flash is ON the imager reads continuously; when

Flash is OFF scanning is deactivated.

Flashing is the recommended scan mode for WLS9600 hands-free

(stand mode) of operation

Always On.

No trigger pull is required to read a barcode. Scanning is continually on. If the

trigger is pulled, the reader acts as if it is in Trigger Single Mode. Double Read Timeout

prevents undesired multiple reads of the same label

while in this mode.

1. Controlled by Flash On Time.

1 2 ... 259 260 261 262 263 264 265 266 267 268 269 ... 305 306

Žádné komentáře

Wasp-barcode WLS9600 Product Reference Guide Uživatelský manuál Strana 264