Wasp-barcode WDI4600 2D Product Reference Guide Uživatelský manuál stáhnout pdf (Strana 238)

References

228

WDI4600

Scanning Features

Scan Mode

This mode is associated with typical handheld reader operation. Selects the scan operating mode

for the reader. The following selections are valid for all models:

Trigger Single:

When the trigger is pulled, scanning is activated until one of the following

occurs:

- Scanning Active Time has elapsed

- a label has been read

- the trigger is released

Trigger Hold Multiple:

When the trigger is pulled, scanning starts and the product scans until

the trigger is released or Scanning Active Time has elapsed. Reading a label does not disable

scanning. Double Read Timeout prevents undesired multiple reads of the same label while in

this mode.

Trigger Pulse Multiple:

When the trigger is pulled, continuous scanning is activated until

Scanning Active Time has elapsed or the trigger has been released and pulled

again. Double

Read Timeout prevents undesired multiple reads of the same label while in this mode.

Flashing:

The reader flashes on and off regardless of the trigger status. Flash rate is controlled by

Flash On Time and Flash Off Time. When Flash is ON the imager reads continuously; when

Flash is OFF scanning is deactivated.

Always On:

No trigger pull is required to read a barcode. Scanning is continually on. If the

trigger is pulled, the reader acts as if it is in Trigger Single Mode. Double Read Timeout

prevents undesired multiple reads of the

same label while in this mode.

Stand Mode:

No trigger pull is required to read a barcode. Scanning is turned on automatically

when an item is placed in the reader’s field of view. If the trigger is pulled, the reader acts as if it

in single read mode. Double Read Timeout prevents undesired multiple reads while in this

mode.

1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 283 284

Žádné komentáře

Wasp-barcode WDI4600 2D Product Reference Guide Uživatelský manuál Strana 238