Wasp-barcode WDI4600 2D Product Reference Guide Uživatelský manuál stáhnout pdf (Strana 35)

RS-232/USB-Com Interfaces Enter/Exit Programming Mode

Product Reference Guide

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and the

beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in

10ms increments. A setting of zero specifies no delay.

See page 215 for more information.

$CR2IC00(CR)

Intercharacter Delay = No Delay

$CR2IC

Select Intercharacter Delay Setting

To configure this feature, scan the ENTER/EXIT

PROGRAMMING MODE barcode above, then the

barcode at left followed by the digits from the

Alphanumeric characters in Appendix D, Keypad

representing your desired character(s). End by

scanning the ENTER/EXIT bar

code again.

Make a mistake? Scan the CANCEL barcode to abort and

not save the entry string. You can then start again at the

beginning.

CANCEL

DEFAULT

00 = No Intercharacter Delay

Beep On ASCII BEL

When this parameter is enabled, the reader issues a beep when a <BEL> character is detected on

the RS-232 serial line. <BEL> is issued to gain a user's attention to an illegal entry or other

important event.

$CR2BB00(CR)

Beep On ASCII BEL = Disable

DEFAULT

$CR2BB01(CR)

Beep On ASCII BEL = Enable

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 283 284

Žádné komentáře

Wasp-barcode WDI4600 2D Product Reference Guide Uživatelský manuál Strana 35